Lines Matching refs:command

37 …throughput, a higher baud rate is necessary, but there's no standard HCI command to change it. Ins…
39 … address. On start, the MAC address needs to be set, but there's no standard HCI command to set it.
41 … to be delivered to the host MCU. Newer Bluetooth standards define a HCI command to configure the …
108 **BD Addr** can be set with vendor-specific command although all chipsets have an official address …
110 **Baud rate** can be set with a custom command.
141 …command complete event for the last command from the init script was sent. BTstack waits for 10 ms…
143 **BD Addr** can be set with a custom command. A fixed address is provided on some modules, e.g. the…
145 **SCO data** can be configured with a custom command found in the bluez sources. It works with USB …
147 …command. The baud rate resets during the warm start after uploading the init script. So, the overa…
192 **BD Addr** fixed to 80:EA:CA:00:00:01. No command in HCI firmware to set it differently. Random ad…
326 **BD Addr** can be set with custom command although all chipsets have an official address stored.
330 …command. The baud rate change of the chipset happens within 0.5 seconds. At least on BTstack, know…
376 … the LMP Subversion returned by the *hci_read_local_version_information* command. TI also uses a n…
386 …CO data:** Routing of SCO data can be configured with the `HCI_VS_Write_SCO_Configuration` command.
388 …command complete event after which the local UART is set to the new speed. Oddly enough, the CC256…
425 **Baud rate** can be set with custom command.
427 **BD Addr ** must be set with custom command. It does not have a stored valid public BD Addr.