Lines Matching +full:m +full:- +full:mode

1 # SPDX-License-Identifier: GPL-2.0
13 	  Technologies USS-720 chip. These cables are plugged into your USB
17 	  The chip has two modes: automatic mode and manual mode. In automatic
18 	  mode, it looks to the computer like a standard USB printer. Only
19 	  printers may be connected to the USS-720 in this mode. The generic
21 	  that mode, and you can say N here if you want to use the chip only
22 	  in this mode.
24 	  Manual mode is not limited to printers, any parallel port
25 	  device should work. This driver utilizes manual mode.
30 	  Say Y here if you own an USS-720 USB->Parport cable and intend to
33 	  To compile this driver as a module, choose M here: the
37 	tristate "EMI 6|2m USB Audio interface support"
39 	  This driver loads firmware to Emagic EMI 6|2m low latency USB
48 	  module, say M here and read <file:Documentation/kbuild/modules.rst>.
59 	  To compile this driver as a module, choose M here: the
68 	  To compile this driver as a module, choose M here.  The module
72 	tristate "USB 7-Segment LED Display"
74 	  Say Y here if you have a USB 7-Segment Display by Delcom
76 	  To compile this driver as a module, choose M here: the
88 	  a module, say M here and read
99 	  To compile this driver as a module, choose M here: the
107 	  driver supports the pre-programmed devices (incl. firmware)
108 	  by AK Modul-Bus Computer GmbH.
110 	  Please see: https://www.ak-modul-bus.de/stat/mikrocontroller.html
112 	  To compile this driver as a module, choose M here: the
124 	  To compile this driver as a module, choose M here: the
154 	  which reports VBUS attach/detach events and has USB-based
155 	  debug and trace capabilities. On selecting m, the module name
166 	  It is safe to say M here.
173 	  This adds support for Intel La Jolla Cove USB-I2C/SPI/GPIO
179 	  will be called usb-ljca.
189 	  To compile this driver as a module, choose M here: the
198 	  To compile this driver as a module, choose M here: the
211 	  To compile this driver as a module, choose M here: the
221 	  See <http://www.linux-usb.org/usbtest/> for more information,
228 	  used for the USB-IF Embedded Host High-Speed Electrical Test procedure.
231 	  VID/PID pairs. This driver then initiates a corresponding test mode on
243 	  http://linux-uvc.berlios.de
253 	  USB port. The YUREX is a leg-shakes sensor. See
255 	  This driver supports read/write of leg-shakes counter and
258 	  To compile this driver as a module, choose M here: the
274 	  Say Y or M here if you need to configure such a device via SMBus.
307 	  To compile this driver as a module, choose M here: the
325 	  but need some non-trivial form of initialization, such as
337 	depends on (USB_ONBOARD_DEV && I2C=y) || (USB_ONBOARD_DEV=m && I2C=m)
343 	  during hub start-up configuration stage. It is must to enable this
345 	  connected to USB-SD converter which mounts the root filesystem.