Searched full:mainly (Results 1 – 25 of 527) sorted by relevance
12345678910>>...22
| /linux-6.14.4/tools/perf/pmu-events/arch/x86/silvermont/ |
| D | frontend.json | 7 …he BACLEARS event counts the number of times the front end is resteered, mainly when the Branch Pr…
16 …he BACLEARS event counts the number of times the front end is resteered, mainly when the Branch Pr…
25 …he BACLEARS event counts the number of times the front end is resteered, mainly when the Branch Pr…
|
| /linux-6.14.4/block/partitions/ |
| D | Kconfig | 169 This is mainly used to carry data from a UnixWare box to your
236 above. This is mainly used to carry data from a SPARC under SunOS to
278 defined in Device Tree. (mainly for eMMC)
|
| /linux-6.14.4/drivers/mmc/host/ |
| D | sdhci-bcm-kona.c | 74 * is very low w.r.t AHB clock, mainly during boot-time and during card in sdhci_bcm_kona_sd_reset()
99 * is very low w.r.t AHB clock, mainly during boot-time and during card in sdhci_bcm_kona_sd_init()
121 * is very low w.r.t AHB clock, mainly during boot-time and during card in sdhci_bcm_kona_sd_card_emulate()
|
| /linux-6.14.4/drivers/hsi/ |
| D | Kconfig | 9 synchronous serial interface used mainly to connect
|
| /linux-6.14.4/Documentation/devicetree/bindings/sound/ |
| D | widgets.txt | 3 This mainly specifies audio off-codec DAPM widgets.
|
| /linux-6.14.4/Documentation/devicetree/bindings/pwm/ |
| D | ti,twl-pwmled.txt | 5 On TWL6030 series: LED PWM (mainly used as charging indicator LED)
|
| /linux-6.14.4/drivers/i3c/ |
| D | Kconfig | 14 mainly designed to communicate with sensors.
|
| /linux-6.14.4/Documentation/ABI/testing/ |
| D | sysfs-bus-hsi | 7 serial interface mainly used for connecting application
|
| /linux-6.14.4/drivers/iio/dummy/ |
| D | Kconfig | 16 Driver intended mainly as documentation for how to write
|
| /linux-6.14.4/Documentation/arch/arm/ |
| D | interrupts.rst | 13 There is more assembly code inside each of these functions, mainly to
48 We also bring the idea of an IRQ "chip" (mainly to reduce the size of
|
| /linux-6.14.4/drivers/gpu/drm/omapdrm/ |
| D | TODO | 6 . This is mainly theoretical since most of these devices don't actually
|
| /linux-6.14.4/drivers/hid/surface-hid/ |
| D | Kconfig | 16 Surface Laptop 3. On those models, it is mainly used to connect the
|
| /linux-6.14.4/fs/squashfs/ |
| D | Kconfig | 171 compressed with LZ4 compression. LZ4 compression is mainly
186 compressed with LZO compression. LZO compression is mainly
|
| /linux-6.14.4/Documentation/devicetree/bindings/pci/ |
| D | snps,dw-pcie-ep.yaml | 56 mainly relevant for the end-point controller configuration,
87 region, but mainly these registers are indirectly accessible
|
| D | snps,dw-pcie.yaml | 65 mainly relevant for the end-point controller configuration,
96 region, but mainly these registers are indirectly accessible
|
| /linux-6.14.4/Documentation/admin-guide/media/ |
| D | ipu6-isys.rst | 29 The Input System mainly works as MIPI CSI-2 receiver which receives and
45 The Input System driver mainly configures CSI-2 D-PHY, constructs the firmware
|
| /linux-6.14.4/Documentation/devicetree/bindings/media/ |
| D | cnm,wave521c.yaml | 43 storing it on DMA memory. It is mainly used for the purpose of reducing
|
| /linux-6.14.4/Documentation/devicetree/bindings/memory-controllers/ |
| D | qca,ath79-ddr-controller.yaml | 14 flush the FIFO between various devices and the DDR. This is mainly used by
|
| /linux-6.14.4/drivers/staging/vme_user/ |
| D | Kconfig | 38 is mainly useful for VME development (in the absence of VME
|
| /linux-6.14.4/tools/testing/selftests/sync/ |
| D | sw_sync.h | 33 * sw_sync is mainly intended for testing and should not be compiled into
|
| /linux-6.14.4/arch/arm/mach-davinci/ |
| D | pm.h | 23 * The SLEEPCOUNT feature is mainly intended for cases in which
|
| /linux-6.14.4/include/sound/ |
| D | sdca.h | 33 * @sdca_interface_revision: value read from _DSD property, mainly to check
|
| /linux-6.14.4/drivers/nvdimm/ |
| D | pfn.h | 36 * configurations mainly to allow a backup, reconfigure the
|
| /linux-6.14.4/include/linux/ |
| D | ti_wilink_st.h | 96 * in progress, this is mainly used to return relevant err codes
230 * mainly used during fw download, which involves multiple send/wait
242 * @core_data: ST core's data, which mainly is the tty's disc_data
|
| /linux-6.14.4/include/asm-generic/ |
| D | checksum.h | 60 * this routine is used for miscellaneous IP-like checksums, mainly
|
12345678910>>...22